Authored by: tomw on Tuesday, December 17 2002 @ 02:45 PM EST

It does work on geeklog 1.3.7 you might be confused with the numbering system. The original staticpages on which staticpages 1.2 was built was 1.1 the version in geeklog 1.3.6 and 1.3.7 is also 1.1 but that is not the same.

After you copied the files you have to run the install page to update the database for 1.2. The only time you don\'t run the install is when you had the original 1.1 installed -- you should have followed the procedure for a clean install of 1.3.6.

The correct upgrade procedure is this.

disable the plugin

copy the files

run the install.php

it works.

Tom

[ Reply to This | # ]

Authored by: tomw on Tuesday, December 17 2002 @ 02:47 PM EST

Oh yeah I forgot to add you have to be logged in as root to run the install program.

Tom

[ Reply to This | # ]

Authored by: anonymous on Wednesday, April 09 2003 @ 03:25 PM EDT

I'm not having any luck installing either. I get the same error as above. I
made sure I was logged in as admin, I untarred the
staticpages_1.2_1.3.6.tar.gz file in the plugins folder and copied all files
where they needed to go. It still get the above error. I am running
1.3.7sr1 also. I went back and reinstalled the original (backups are
always good) and it worked fine. I then just replaced the files that
needed it but still the same error. I always un-install a plugin before I do
any of this. Now this may be a stupid question but does the
staticpages_1.2_1.3.6 mean it's for GL-1.3.6 only?

[ Reply to This | # ]